By the drew (Pawn707) (68.164.88.163) on Friday, January 24, 2003 - 01:01 am:

Sometimes, even with the proper content directory selected, I'll load a model and it says "no disc inserted in E: (my CD-rom)" and it wants me to select the files by hand...?

By Matt Gorner (Matt) (217.37.13.153) on Friday, January 24, 2003 - 03:38 am:

Check the modeller config file (LWM3.CFG) for any reference to your E-Drive, they may be something that has slipped past.

Then make sure Modeller is using that config file.

By Vince Lebish (Lebish) (64.12.96.79) on Friday, January 24, 2003 - 04:05 am:

Make sure your content drive..is the one you want also.. hit 'o' and check..

By the drew (Pawn707) (68.164.88.163) on Friday, January 24, 2003 - 02:04 pm:

Ah, sure enough there was a line referencing the E: drive. That's an interesting little file to look through...I'll remember that in the future!

Incidentally, why would the E: drive remain as a content directory when I repeatedly changed it to a C: directory? Does LW establish a "primary" content directory when it's installed or something?

thanks again everyone

By Elmar Moelzer (Elmar_Moelzer) (62.47.36.118) on Friday, January 24, 2003 - 02:11 pm:

Hey Drew
If youa re using LW without Hub make sure to set the content- dir not only in Layout, but also in Modeler. Also if you happen to crash layout/Modeler after setting the new Content- dir it will not be saved. Oh and make sure your config- file is not write- protected or something (for whatever odd reason)...
CU
Elmar