somnambulance
08-02-2004, 11:46 PM
Ok, I had SN up and running and rendered sever scenes. At some point last night one of the nodes on my dual crashed. Now when I try to run LWSN2, it doesnt work.
It should read this:
LightWave command: wait.
but it reads this (just before it quits):
LightWave command: quit.
Now I tried deleting LWSN2 and LWSN2 cmndLine and making new ones but that didnt work. So I tried deleting all the prefs and reinstalling, but that didnt work either.
Keep in mind, it was working and crashed in the middle of a render batch list (I think when it changed to a new scene).
If anyone knows, please help!
It should read this:
LightWave command: wait.
but it reads this (just before it quits):
LightWave command: quit.
Now I tried deleting LWSN2 and LWSN2 cmndLine and making new ones but that didnt work. So I tried deleting all the prefs and reinstalling, but that didnt work either.
Keep in mind, it was working and crashed in the middle of a render batch list (I think when it changed to a new scene).
If anyone knows, please help!