xerxesnon
05-26-2003, 09:48 PM
Hey all -
We are getting our brand new Toaster system this week, and would like to get some recommendations on some good mobile case solutions for remote shoots.
The system case is a standard 60 lb Aluminum Tower, and we've got a 17" Flat Panel, and would also need space for a few rack mount units. It has to have steady casters for rolling around pavement and stuff.
I was thinking about an Anvil case solution with a Modular Interlocking System like these, where I could just roll the entire workstation up to a remote shoot, take the front and back off, pop out the table extension, and run the whole system from within the case.
http://www.anvilcases.com/html/Anvil_products/MICS_Anvil.htm
Has anyone out there set up a similar solution or have some thoughts around what might work the best?
Thanks in advance...
XN
We are getting our brand new Toaster system this week, and would like to get some recommendations on some good mobile case solutions for remote shoots.
The system case is a standard 60 lb Aluminum Tower, and we've got a 17" Flat Panel, and would also need space for a few rack mount units. It has to have steady casters for rolling around pavement and stuff.
I was thinking about an Anvil case solution with a Modular Interlocking System like these, where I could just roll the entire workstation up to a remote shoot, take the front and back off, pop out the table extension, and run the whole system from within the case.
http://www.anvilcases.com/html/Anvil_products/MICS_Anvil.htm
Has anyone out there set up a similar solution or have some thoughts around what might work the best?
Thanks in advance...
XN