Adams Arms Gun Cut-Away

Toe_Knee · 11-05-2009, 04:32 PM

This is a image I did for an article in Tactical Operator for Adams Arms.

This is a barrel cut away to show how the hot gases travel through the barrel, up the gas block and out the drive rod.

I also made a couple videos showing how the gun functions and installing the system on a standard M4 Carbine.

you can see them at http://adamsarms.net/content.asp?content=10

Check them out

Toe_Knee

G M D THREE · 11-06-2009, 02:58 AM

Hey, nice job Tony.

///

OnlineRender · 11-08-2009, 12:05 PM

very nice smooth animation I noticed the riot gear effects at the start, I think there becoming a little over used in my opp . everyone seems to follow the VC techniques ,other than can't complain about the animation work .

Toe_Knee · 11-09-2009, 07:35 AM

Thanks G... hope everything is going well over at the studio...

Onlinerender... Thanks for the comments... I know what you mean about the VC footage... I actually didn't make that beginning, only the animation. That was done by the Candy Factory out of Tampa... but a lot of people in the gun industry don't know what Video Copilot is... so it works out in the end