Amiga Video Toaster / Flyer FAQs
  Amiga Flyer
    Flyer Hardware Issues
      Recorded Video Plays Hot

Product: Flyer

Platforms: 2000 3000 3000T 4000 4000T

Problem: Passthrough video looks normal while recording, but on playback the video is too hot.

1. The first solution the user should try is simply to run FlyerCalibrate to properly calibrate the Record and playback channels of the Flyer.

2. Check for proper termination on the last device on program output. Even small errors in the termination level can cause video to record hot.

3. Check the luminance gain on the input device. The Flyer is sensitive to how gain is set on the input deck or TBC.

4. Check the horizontal position of the incoming video. In particular, some TBCs designed for use with computer video systems increase the overscan of video passing through the TBC. This can result in active video where the Toaster/Flyer expects the "back porch" portion of the video signal. If this is the case, moving the video slightly to the right with the TBC's horizontal position adjustment will clear up the problem.

5. Check cables and connectors.

6. Check to see if the problem occurs only when a particular device is used on input or output. If a particular device is the source of the problem, have the device checked by authorized service personnel.

7. If all other options do not resolve the problem, the technically skilled user or an experienced service technician may attempt a manual calibration of the Flyer. See: FlyCal archive on our FTP site.

See also:

• Autohue;
• Video Toaster Output is Hot;
• Manual Toaster Calibration;
• Manual Phase Adjustment for Flyers.