Amiga Video Toaster / Flyer FAQs
  Amiga Flyer
    Flyer Hardware Issues
      Termination Power Settings

Product: Flyer

Platforms: 2000 3000 3000T 4000 4000T

Problem: What is the correct jumper setting for termination power - draw power for termination from the drive or the SCSI bus?

Set termination power to "From drive only", with any drive that has a jumper for selecting either the drive or the SCSI host as the source power to the terminators.

Any demand on the SCSI Host termination power line causes problems for the Flyer. Drives should not draw termination power from the SCSI bus. If possible, the user should also not set a drive to feed termination power to the SCSI bus, but with modern drives that require external terminators the situation may be unavoidable.